oil, gas, etc: 185.0 kg (407.9 pounds) Seat height: 690 mm (27.2 inches) If adjustable, lowest setting. Physical measures Dry weight: 174.0 kg (383.6 pounds) Weight incl. dual 29.3mm venturi Valves per cylinder: 3 Fuel control: DOHC Ignition: capacitive discharge Starter: Electric Lubrication system: wet sump Cooling system: Air Gearbox: 6-speed Transmission type final drive: Chain Clutch: wet, multi-plate More details Consult a Honda repair manual.

Clean it down good, i like to take some fine steel wool and shine it up and then apply a little grease to it as well.1986 Honda Rebel 450 Honda, Fresh: Carb Clean Plugs Pet Cock Oil Change Fuel Flush New Pipes Consignment unit Engine and transmission Displacement: 447.00 ccm (27.28 cubic inches) Engine type: Twin Stroke: 4 Power: 38.00 HP (27.7 rkW)) 8000 RPM Compression: 9.3:1 Bore x stroke: 75.0 x 50.6 mm (3.0 x 2.0 inches) Fuel system: Carburettor. Make sure the shaft is clean before pushing it into the new seal or you will score it and ruin it. If thats leaking oil at all get a new copper sealing washer from an local auto parts store to fix that. The rest of the assembly is just the reverse, don't overtighten that 10mm bolt, just spin it down finger tight, then snug it up with a wrench, i mean lightly snug. Grease the seal up on the inside lip that the shaft runs on, a little assembly lube or light grease is fine, this will prevent damage while putting the shaft back in but also to keep it lubricated for use.

Get a new seal, pull the old seal, push the new seal in as much as you can by hand then tap it the rest of the way with a rubber mallet or a wooden dowel and small, don't go pounding on it, just a few light taps to seat it all the way. Once the cable is removed look on the top of the head where the lever return spring is, there is a single 10mm bolt with a metal sealing washer on it, remove that 10mm bolt then pull the decompression lever shaft right out of the rocker cover. Remove the cable from the lever, i usually just loosen the cable holder and pull the cable out of that then pull the lever up by hand to get slack in the cable and then turn the end and remove it from the lever.

Rings 1982 honda atc 185